Introduction
IMPORTANT NOTES, READ BEFORE INSTALLATION
- Never unscrew the banjo bolts on the hoses to reorient them
- Do not bend the hoses at a 90° angle
- Do not route the hoses near a place where it can become clogged
- Do not route the hoses near extreme heat generating parts (ie: exhaust)
- Do not over tighten the metal collars on the reservoirs (torque to 6 lbs/in)
- Make sure reservoir stays clear form any moving parts (ie: swingarm, chain)
- Hoses must be secured to the frame using zip ties to avoid contact with moving parts
- Make sure that the shock bolts and metal collars are fastened properly before riding
-
-
Banjo bolts must face towards the front of the vehicle with their attachement point towards the left side.
-
The reservoir must be attached to the rear subframe using the provided rubber holders and metal collars. Make sure to route the hose according to the pictures.
-
The compression adjustment knobs should be facing the back of the quad for convenient access.
-
The rebound adjuster (compact model, adjustable using a screwdriver) located at the bottom of the shock should face the rear of the quad for convenient access. The bottom eyelet of the shock can be turned 180° if needed.
-
