-
-
Lift the vehicle off the ground, then remove the wheels.
-
Remove the bolt that holds the brake line on each side to ensure that it will not be damaged and stretched during installation.(right side show)
-
Remove the bolt that holds the ABS sensor of the knuckle.
-
-
-
Remove the skid plate.
-
Remove the sway bar link on both side.
-
Remove the sway bar.
-
-
-
Remove the nuts from the tie rod
-
Remove upper arm ball joint nut and seperate it from steering knuckle.
-
Remove the bolts from the lower shock mounts
-
-
-
Remove the 3 nuts of the upper shock.
-
Remove the shock from the vehicule.
-
-
-
Clean the sway bar area.
-
Install the sway bar relocation kit. Make sure the block is installed as shown. The red arrow is pointing to the front of the truck.
-
Install the relocation kit on both side.
-
-
-
The skid plate need to be trimed before reinstall.
-
Cut the red triangle of the skid plate on bot side.
-
Mesure 1.5'' on both side to make the cutting line.
-
-
-
Install the Elka shocks using provided lower bolts and the provided upper bolts. Hoses must face the front of vehicle as shown (right side shown).
-
Install the bracket of the reservoir on top of the shock mount.
-
The bracket of the reservoir is fix with the same bolt of the top plate.
-
Install the 3 uppers bolts and torque to 35 Ft-Lbs.
-
-
-
Sit the reservoir into the bracket clamps, then place the reservoir in such a way as to place the hose properly. BE CAREFUL TO NOT OVERBEND THE HOSE OR CREATE RUBBING ON FRAME.
-
When the reservoir is placed properly, torque bracket's bolts at 10 Ft-Lb.
-
-
-
Reinstall the lower pin bolt and torque to 50 Ft-Lb.
-
Reassemble the knuckle with the upper control arm. Torque the upper control arm nut to 70 Ft-Lb.
-
Reassemble the tie rod end, then torque the nut to 70 Ft-Lb.
-
Reinstall the brake line bolts.
-
Reinstall the ABS line bolts.
-
Reinstall the sway bar.
-
Reinstall the sway bar link on both side.
-
-
-
Reintall the skid plate.
-
-
-
Remove upper and lower bolts from OEM shocks. Keep OEM bolts to install Elka shocks.
-
-
-
Both side : Oriente the reservoir of the shock on the rear of the vehicle
-
Using an underhoist stand or a jack, lift rear axle to be able to install lower bolt.
-
Torque all bolts as manufacturer's specs.
-
